Momentive RTV103 silikonová, jednodílná, černá, 300ml cartridge

Brand:Momentive

3.9/5

1327.07

Univerzální, jednosložkový silikonový tmel, který vytvrzuje na houževnatý, odolný a pružný silikonový kaučuk při vystavení atmosférické vlhkosti při pokojové teplotě. Produkt se standardní pevností v konzistenci pasty, který lze aplikovat na svislé povrchy a povrchy nad hlavou, kde nejsou praktické lité/samonivelační tmely. Má vynikající výkon při nízkých a vysokých teplotách -75° až 400°f. lze použít v aplikacích pro styk s potravinami, kde platí předpisy FDA odkaz: Cds4319. uznáno UL pod souborem UL e-36952.

Splňuje vojenskou specifikaci mil-a-46106 a nsf standard 51, je kompatibilní s fda 21 cfr 177.2600, je kompatibilní s usda a má součásti uznané ul. Rozsah nepřetržitého provozu je -75 až +400 stupňů f (-60 až +204 stupňů c) a rozsah přerušovaného provozu je -75 až +500 stupňů f (-60 až +260 stupňů c). Přilne k mnoha kovům, sklu, keramice, silikonové pryži a některým tuhým plastům bez použití základního nátěru. Konzistence pasty umožňuje aplikaci na svislé nebo nad hlavou. Jednosložkový černý rtv silikonový tmel s pastovou konzistencí pro vyplnění a utěsnění mezer nebo prasklin do 1/4 palce.
Country of Origin USA
Item model number RTV103-300ML
Manufacturer Momentive
Package Dimensions 11 x 1.5 x 0.94 inches; 10.41 Ounces

3.9

8 Review
5 Star
83
4 Star
17
3 Star
0
2 Star
0
1 Star
0

Napište svou recenzi

Váš email nebude zveřejněn. Všechna povinná pole jsou označena*

Scritto da: Wakawaka
Actual silicone is great, packaging no so much
So far I’m in for 7 tubes of this stuff and have had the same issue to varying degrees with all tubes. The plunger bypasses a ton of the silicone! Not only have I lost about 5-10$ worth of product every tube but my electric gun is a MESS. Yes I used a manual version too, and tried adding a fender washer to make sure I was supporting the entire plunger - same issue. I did cut my tips small and noticed that going slow reduced the loss but it shouldn’t be happening at all. Initially the directions fail to mention that you must puncture the inner seal after cutting tip. Not a big deal but threw me for a loop right off the bat because normally only cardboard adhesives have the seal and these tubes are plastic. Actual silicone is great quality, using it for fish tank stuff. I had success bonding acrylic to glass (over flow and sump building) and injecting it to reseal a stupid craigslist tank. One thing to note, if you’re using tape at the seam which you plan to remove while the silicone is still wet to get a clean line, you need to pull it off right after completing the seam. If you wait the typical 5 mins you’ll risk pulling the silicone OUT of the seam with the tape instead of just the excess that ran onto the tape.
Scritto da: ScottH
Sets up pretty quickly
It does grow a skin pretty quick, so you don't have heaps of time to get your bead looking the way you want. I found it stuck a little to the blue tape I was using as a mask. Not a big deal, but be prepared for it.
Scritto da: James daniels
This is what you want for fishtank's also, its black!
This is the best on the market for its application in fishtanks, its wayyyy better than silicone. Worth the expense. Just repaired a 3500 dollar fishtank i bought for 300 bucks with it.
Scritto da: I Buy Too Much
Works Like A Charm!
I chose this item due to the reviews regarding fish tanks. Had to reseal used bow front tank. Used frog tape to make perfect bead lines. Go slow by steady your caulk gun to get one continuous bead. Cut the caulk top to the size of bead you want to achieve. Do one pass with wet finger. Don't use a dry finger!!! Then do not touch it! Have wet paper towels ready as it can be messy. After drying I used a scraper to get off any random caulk. Do not scrap any part of aquarium side/bottom seal.If you made it messy, leave it. You do not want to break the cured seal. I waited until the vinegar smell was gone (about 40 hours as my tank was in garage) to rinse out and set up. Awesome product!
Scritto da: Brent Custer
Perfect
Caulking was perfect no hard spots. Great product and will buy again for sure
Scritto da: Bill
Used it to seal a 26 gallon tank worked excellent
Used it to seal a 26 gallon tank worked excellent
Scritto da: Tom Dehnert
Very strong aquarium safe
The best stuff period for redoing the inside of a fish tank
Scritto da: Mike jones
The best stuff around for Aquariums
Very strong, and very fast drying. Used it to repair damaged seals in a Waterbox rimless aquarium.

Související produkty

hot
3.7/5

Kč 1133.77

3.7/5

Kč 1133.77

Objevte naši mezinárodní síť

Dodáváme do 28 zemí, více než 200 000 produktů. Zůstaňte v obraze, přihlaste se k odběru newsletteru.

Array