Rain Bird 12DSH dvojitá rozprašovací tryska, 180° půlkruhový vzor, ​​9' - 12' stříkací vzdálenost půlkruh 180° vzor 180° půlkruhový

Brand:Rain Bird

3.7/5

500.57

POPIS PRODUKTU Rain Bird 12DSH Dual Spray 180° půlkruhový vzor s přizpůsobeným srážkovým vzorem, nastavitelná vzdálenost stříkání 9' až 12', 23° trajektorie. Tato speciální tryska má dva rozprašovací otvory pro lepší zavlažování a rovnoměrnější distribuci vody. Jedinečný patentovaný design podříznutí zkracuje dobu zavlažování, spotřebuje o 30 % méně vody a snižuje plýtvání vodou ve větrných podmínkách. Oblasti v blízkosti hlavy jsou pokryty rovnoměrně a minimalizují se suché hnědé skvrny. Nekorodující plast a nerezová konstrukce pro dlouhou životnost. nastavovací šroub z nerezové oceli nastavuje průtok od 1,8 do 2,6 galonů za minutu a vzdálenost stříkání od 9' do 12'. Zachycený otvor pro šroub zabraňuje sklouznutí šroubováku během nastavování. Tryska stříká 180° půlkruhový vzor v 23° trajektorii a hodí se pro všechny postřikovače Rain Bird a adaptéry na keře. Jemné síto filtru udržuje přesné nastavení poloměru a chrání spodní otvor před nečistotami. Trysky Rain Bird MPR, které jsou důvěryhodné po celá desetiletí, jsou vybaveny technologií distribuce vody Matched Precipitation Rate. Trysky s proměnlivými oblouky a poloměry lze míchat ve stejné zóně bez ohledu na nastavení postřiku a stále zachovávají rovnoměrné rychlosti distribuce vody. K dispozici je široký výběr trysek MPR, takže distribuci vody lze přizpůsobit tak, aby vyhovovala jedinečným a různorodým potřebám vaší krajiny. Trysky MPR jsou navrženy tak, aby poskytovaly rovnoměrné pokrytí a zajistily, že váš trávník bude zelený po celém povrchu bez suchých nebo hnědých skvrn. Další dostupné trysky Dual Spray MPR (prodávají se samostatně): 360° plné (12DSF) a 90° čtvrtinové (12DSQ) vzory. Rain Bird „Inteligentní využití vody OD VÝROBCE Rain Bird Corporation je soukromá společnost založená v roce 1933 během zemědělského boomu v Kalifornii. Jsme uznáváni jako #1 výrobce a poskytovatel zavlažovacích produktů a služeb na světě. S prodejními kancelářemi po celém světě; nabízíme více než 4 000 produktů pro zavlažování šetřící vodu ve více než 130 zemích. Od samého počátku Rain Bird vyrábí a nabízí nejširší sortiment vysoce kvalitních zavlažovacích produktů pro: farmy, golfová hřiště, sportovní arény, komerční budovy a domácnosti. Za posledních 80 let obdržel Rain Bird více než 450 patentů po celém světě. Včetně prvního pro zavlažování v roce 1935 na našem původním postřikovači s nárazovým pohonem (US patent č. 1 997 901), který způsobil revoluci ve výrobě zemědělských potravin a zahájil novou éru v zavlažování po celém světě. V roce 1990 byl tento originální nárazový postřikovač označen Americkou společností zemědělských inženýrů za historickou památku. Naše produkty pokrývají všechny aspekty zavlažování…časovače/ovladače, výsuvné rotační postřikovače, výsuvné postřikovače s rozstřikovacími hlavicemi, postřikovací trysky, zavlažovací ventily, kapkové zavlažování, odvodnění a mnoho dalšího. Tyto produkty byly vybrány a instalovány po celém světě v největších a nejprestižnějších projektech pro zavlažování obytných, komerčních, zemědělských a golfových hřišť. Rain Bird se zavázal k programu The Intelligent Use of Water™, který přesahuje produkty do vzdělávání, školení a služeb pro průmysl a komunitu. Naším odkazem je navrhovat a vyrábět pouze produkty nejvyšší hodnoty a kvality. Jsme vděční, že jsme obdrželi řadu ocenění od mnoha našich vážených partnerů. Rain Bird „Inteligentní využívání vody

Vyrobeno z vysoce odolných materiálů odolných proti UV záření a chemikáliím pro zajištění dlouhé životnosti. Seřizovací šroub z nerezové oceli upravuje průtok a vzdálenost postřiku. Odstraňuje suché hnědé skvrny v blízkosti hlavy. Kompatibilní se všemi výsuvnými zavlažovači Rain Bird. 180° půlkruhový vzor s nastavitelnou vzdáleností stříkání 9' až 12'. Spotřebuje o 30 % méně vody; snižuje plýtvání vodou ve větrných podmínkách. Dvojité trysky pro dokonalé zavlažování.
Brand Rain Bird
Color Brown/Black
Country of Origin USA
Customer Reviews 4.7 4.7 out of 5 stars 276 ratings 4.7 out of 5 stars
Domestic Shipping Item can be shipped within U.S.
International Shipping This item can be shipped to select countries outside of the U.S. Learn More
Is Discontinued By Manufacturer No
Item Dimensions LxWxH 0.89 x 0.89 x 2.1 inches
Item model number 12DSH
Item Weight 0.022 ounces
Manufacturer Rain Bird
Material Stainless Steel
Product Dimensions 0.89 x 0.89 x 2.1 inches
Style Pop-Up

3.7

7 Review
5 Star
75
4 Star
20
3 Star
3
2 Star
0
1 Star
2

Napište svou recenzi

Váš email nebude zveřejněn. Všechna povinná pole jsou označena*

Scritto da: Eugene
Better near and far spray coverage
To adjust the spray distance and water output of this nozzle, turn the screw on top counterclockwise for an increase, or turn it clockwise for a decrease. To adjust which direction it sprays, you can remove the top of the sprinkler head and reinsert the nozzle tube. Some sprinkler heads are installed deep enough that pulling the top off is undesirable, so you can pull up the nozzle tube and twist it until it's rotated in the right direction. It should make clicking noises as it is turned. If there's no clicking, then you may be unscrewing the sprinkler from the pipe beneath it, or unscrewing the top of the sprinkler, so I prefer to turn it clockwise. I use this nozzle wherever I don't need an adjustable nozzle because it does a better job of providing even coverage both near and far. It works great wherever my sprinklers pop up high enough, which in my lawn requires at least a 4 inch sprinkler. I have a couple 2 inch sprinklers that don't come up enough, so the dual spray part of this nozzle sprays directly into the grass right next to it. It's not the fault of the nozzle, but a notification that I should swap out that sprinkler head. I've also found that this nozzle can directly replace some of the nozzles on my Orbit sprinklers. My only gripe with this nozzle, and all Rain Bird nozzles, is that the adjustment screw tightness has a lot of variation. Sometimes it's so tight that the nozzle must be pulled up and gripped tightly to adjust it, which results in a face full of water if you try this while the sprinklers are on, but other nozzles are loose enough that they can be adjusted just by turning the screw without holding onto the nozzle. Fortunately giving the adjustment screw a few turns to loosen it up before installing it is all it takes to resolve this minor issue.
Scritto da: Eugene
Good near and far spray coverage
To adjust the spray distance and water output of this nozzle, turn the screw on top counterclockwise for an increase, or turn it clockwise for a decrease. To adjust which direction it sprays, you can remove the top of the sprinkler head and reinsert the nozzle tube. Some sprinkler heads are installed deep enough that pulling the top off is undesirable, so you can pull up the nozzle tube and twist it until it's rotated in the right direction. It should make clicking noises as it is turned. If there's no clicking, then you may be unscrewing the sprinkler from the pipe beneath it, or unscrewing the top of the sprinkler, so I prefer to turn it clockwise. I use this nozzle wherever I don't need an adjustable nozzle because it does a better job of providing even coverage both near and far. It works great wherever my sprinklers pop up high enough, which in my lawn requires at least a 4 inch sprinkler. I have a couple 2 inch sprinklers that don't come up enough, so the dual spray part of this nozzle sprays directly into the grass right next to it. It's not the fault of the nozzle, but a notification that I should swap out that sprinkler head. I've also found that this nozzle can directly replace some of the nozzles on my Orbit sprinklers. My only gripe with this nozzle, and all Rain Bird nozzles, is that the adjustment screw tightness has a lot of variation. Sometimes it's so tight that the nozzle must be pulled up and gripped tightly to adjust it, which results in a face full of water if you try this while the sprinklers are on, but other nozzles are loose enough that they can be adjusted just by turning the screw without holding onto the nozzle. Fortunately giving the adjustment screw a few turns to loosen it up before installing it is all it takes to resolve this minor issue.
Scritto da: Dazzza
Great Replacement at Low Cost
These nozzles fit the 1800 series and UNI-Spray series sprinkler head bodies. They will also fit onto most other brands of sprinklers that use universal female thread nozzles. While Rainbird makes a wide range of nozzles, most are only available at specialty irrigation stores. Hardware stores and home centers tend to only carry a few of the most common nozzles. Rainbird makes a very good nozzle set with good water spray uniformity. Many of them have matched precipitation rates so you can mix different radius and pattern nozzles on the same valve zone without messing up the water application uniformity. Be careful of this as Rainbird's literature calls all of their nozzles "matched precipitation rate", but that does not mean they are all compatible with each other! For example, you should not use a 4 series VAN nozzle on the same valve circuit as a 5 series MPR nozzle. Read the nozzle descriptions for each series of nozzles below for details on which nozzles are compatible. The spray radius can be reduced up to 25% on all but a few specialty bubbler nozzles using a screw on top of the nozzle. Note that the separate screen must be installed under the nozzle for the radius adjustment to work correctly. If you remove or don't install the screen you won't be able to adjust the radius. The screens are provided with the nozzles when you purchase them. All Rainbird nozzles are constructed of high-quality plastic.
Scritto da: Padmapada
Easy fix for a damaged sprinkler head, saved lots of $$$
The folks who cut my grass tend to cut the heads off the sprinklers with their machines. In the past, I've called the sprinkler company to fix them, and ended up paying hefty service calls. This time I had a look and saw that the damaged head simply unscrewed. So I went to the local big box store and tried to find a replacement. The clerk tried to talk me into buying something that had threads on the OUTSIDE because, I guess, that is what he had in stock. But I needed a head with threads on the inside, one that would just screw down on top of the pop-up pipe. I saw this on Amazon and asked other customers if it had threads on the inside, and the answer was positive. So I bought this, and it took about 2 minutes to install. The head is clearly marked so that you can see which way the spray goes (this is a half circle), and there is a screw on top to reduce the diameter if you want. It is installed in the berm, or tree lawn, or verge, or curb strip, or whatever you call that narrow strip of lawn between the sidewalk and the street. Perfect. Good for all dialects.
Scritto da: Cindy
Good product
Product fit as described
Scritto da: Amazon Customer
Performance met the product description.
Did a lot better than the water savors you can buy.
Scritto da: Brenda Brennan
Perfect fit
Perfect to replace broken sprinkler head.

Související produkty

Objevte naši mezinárodní síť

Dodáváme do 28 zemí, více než 200 000 produktů. Zůstaňte v obraze, přihlaste se k odběru newsletteru.

Array