Vzduchový zvedák s trojitým vakem Mophorn, kapacita 3 tuny (6600 lbs), přenosné pneumatické zvedáky do auta, rychlé zvedání až do výšky 16 palců, vysoká zátěž a rychlé zvedání pro garážové opravy, červená krátká rukojeť

Brand:Mophorn

3.6/5

7034.87

Široké použití: Rychlý zvedák na auto je ideální pro situace, kdy je třeba zvednout jedno kolo v měkkém terénu, vodě na písku nebo blátivých cestách pro rodinné automobily, minivany, SUV a terénní vozidla. Prostorově úsporný design: Konstrukce rukojeti se přizpůsobí tvaru ruky, takže můžete zvedák plně ovládat, když jej používáte. A celá konstrukce je kompaktní a snadno se skladuje. Můžete jej tedy pohodlně vzít ven. Bezpečné použití: Nejprve nechte červený ventil uzavřený, otevřete zelený ventil a vložte stlačený vzduch; při nafouknutí do výšky vypněte zelený ventil. Po použití otevřete červený ventil, abyste vypustili vzduch. Pojistný ventil uprostřed zajišťuje, že vstřikovaný plyn není nadměrný, aby byla zajištěna bezpečnost procesu použití. Konstrukce pro těžký provoz: Náš pneumatický zvedák je vyroben z vysoce pevné oceli, díky které je celé tělo robustní a odolné. Ocelový rám s práškovým nástřikem a pryžová shoda pro snížení nárazu. Vysoce utěsněné airbagy nebudou prosakovat ani se nepoškrábou. Větší namáhaná plocha se vejde na měkké a snadno skládací místo. Zvedák šetřící práci: Kapacita pneumatického zvedáku: 6600 lbs/3T. Minimální výška: 5,3/135 mm. Maximální výška: 15,75/400 mm. Zvednutí trvá pouze 5 sekund. Pracovní teplota: -60 ℃ ~ 50 ℃. Vstup vzduchu: G1/4. Náš trojitý zvedák je nejjednodušší a nejrychlejší způsob, jak zvednout auto.

Nejsou k dispozici žádné jednotky
Široké použití: Rychlý zvedák na auto je ideální pro situace, kdy je třeba zvednout jedno kolo v měkkém terénu, vodě na písku nebo blátivých cestách pro rodinné automobily, minivany, SUV a terénní vozidla. Prostorově úsporný design: Konstrukce rukojeti se přizpůsobí tvaru ruky, takže můžete zvedák plně ovládat, když jej používáte. A celá konstrukce je kompaktní a snadno se skladuje. Můžete jej tedy pohodlně vzít ven. Bezpečné použití: Nejprve nechte červený ventil uzavřený, otevřete zelený ventil a vložte stlačený vzduch; při nafouknutí do výšky vypněte zelený ventil. Po použití otevřete červený ventil, abyste vypustili vzduch. Pojistný ventil uprostřed zajišťuje, že vstřikovaný plyn není nadměrný, aby byla zajištěna bezpečnost procesu použití. Konstrukce pro těžký provoz: Náš pneumatický zvedák je vyroben z vysoce pevné oceli, díky které je celé tělo robustní a odolné. Ocelový rám s práškovým nástřikem a pryžová shoda pro snížení nárazu. Vysoce utěsněné airbagy nebudou prosakovat ani se nepoškrábou. Větší namáhaná plocha se vejde na měkké a snadno skládací místo. Zvedák šetřící práci: Kapacita pneumatického zvedáku: 6600 lbs/3T. Minimální výška: 5,3/135 mm. Maximální výška: 15,75/400 mm. Zvednutí trvá pouze 5 sekund. Pracovní teplota: -60 ℃ ~ 50 ℃. Vstup vzduchu: G1/4. Náš trojitý zvedák je nejjednodušší a nejrychlejší způsob, jak zvednout auto.
Brand Mophorn
Brand ‎Mophorn
Color ‎Red
Country of Origin ‎China
Customer Reviews 4.5 4.5 out of 5 stars 337 ratings 4.5 out of 5 stars
Item Dimensions LxWxH ‎20.5 x 19.7 x 7.5 inches
Item model number ‎3T16INR
Item Weight ‎36 Pounds
Load Capacity 3 ton
Load Capacity ‎3 ton
Manufacturer ‎Mophorn
Manufacturer Part Number ‎3T16INR
Material Alloy Steel
Material ‎Alloy Steel
Maximum Lifting Height 400 Millimeters
Maximum Lifting Height ‎400 Millimeters
Minimum Height ‎5.3 Inches
Model ‎3T16INR
Product Dimensions ‎20.5 x 19.7 x 7.5 inches
Style ‎Short Handle
Vehicle Service Type Car
Vehicle Service Type ‎Car

3.6

13 Review
5 Star
75
4 Star
13
3 Star
7
2 Star
2
1 Star
4

Napište svou recenzi

Váš email nebude zveřejněn. Všechna povinná pole jsou označena*

Scritto da: Fritz
Works great
Overall height is 6” when down. Before you hook up air hose. With both valves open push airbag down and while still holding down close both valves. That will make the overall height 5 1/2”. If you install the handles it will then be 6 1/2” overall height. I left the handles off so I get more clearance when putting under lower cars. It is heavy but easy enough to slide under car into position without the handles. Lifts car without any hesitation. You can regulate how fast it goes up and how far by slowly opening air valve and then shutting off. When lowering it has an exhaust restriction so it goes down slow. Plus you can just partly open exhaust if you want to go down slower and close it again if only wanting to lower part of the way. It also has a over pressure safety valve. You will probably need to trim 1/4-3/8” off the plastic hose when putting it together. That way it isn’t kinked and restricting airflow. Airbag feels heavy duty and should last a long time. But always use jack stands incase the bag did pop. Much nicer to use in tight garage then floor jack with long handle sticking out in the way.
Scritto da: Stickman
Almost, but not quite. Has some serious flaws. Read before you buy.
There are a ton of these types of jacks on Amazon, not sure if they are all made by the same but this one has 2 serious issues. #1 When you go to store it in the upright position, it almost tips over. Just a slight bump and it will tip over. If you are like me, your garage is full of cars and you put stuff like this along the side walls, near the car when it's parked. If you do that and if you or anyone just bumps it, it can tip over and fall into your car. The flaw is the little legs are welded in the wrong position. (and see #2 below). There is no way to bend them so I tried fixing #2 below to see if that would help but it did not. #2. The handle bends way too much (up, or away from center.) This actually can put the controls in contact with the bottom of the car if your car is low and/or you are positioning the jack from one side to the far other side or even the middle depending on the car. This bend also compounds the problem of it tipping over because the valve assembly is heavy and way past center of the whole unit. To fix these issues I tried: Bending the handle to take some of the bend out. This helped a little but not much. The next thing I'm going to do is wele a small 1/2" metal tube across the "legs" at the bottom to elevate that end of the jack so the unit is more centered in it's balance when positioned vertically. I'm pretty sure this will solve the problem. I'm not sure if I just got a bum one or if they are all like this. Otherwise it's a good jack. If you store it on the floor in a horizontal position you'll never notice these flaws. But if you try to store it vertically (like it's designed to do) you will find the problems. Good luck.
Scritto da: travel tools
Decent jack
The media could not be loaded. The screw holding the top pad is stripped out of the box! Will have to fix but seems otherwise a good jack and can lift my >8500# motorhome with a big enough compressor. A small off-road compressor won't do the trick. Possibly a pancake compressor would?
Scritto da: Mike64
Awesome jack! Power lifts if not watching it.
I used this to do tire work on a trailer. It blasts it up in the air if you’re not careful. Just a perfect jack for height adjustment, either too high or low. It has a great range of heights too.
Scritto da: Amazon Customer
Nice product
Nice jack and pretty stable. I have used it a few times now and I am happy with it. it does seem to lean towards one side when I lift. However the more I use it and position it I find it working better. As with all lifting equipment pay attention and be aware of what you are doing! When you give it air it can move VERY fast!
Scritto da: Dave B.
Performs well. Love it
It required some simple assembly. I checked other fasteners and hose as some others had complained about these. Mine was perfect. My portable DeWalt air compressor supplied enough pressure to easily lift the back end of my Mustang. You can control the rate of lift by opening the green valve slowly and partially. You can also stop it part of the way up. Definitely use jack stands. It settled on my lift with it partially elevated. I did not hear any air leaks, so I assume it came from the jack. I expect to get a lot of use with this.
Scritto da: Jason Musgrave
Awesome device!
Product is solid and works well. I actually used it to level out some deck joists so I could establish new footers. Will come in handy with many applications !!
Scritto da: Anthony Porter
Does the job
I am pleased with this product
Scritto da: steve gagnon
un bon produit sauf tuyau serrage
embout ou connecte le tuyau de plastique trop fragile a casser au premier serrage
Scritto da: mado
robuste
parfait mon chum l adore
Scritto da: wendell
works good
lot better than the old floor jacks. just dont get under without a block or jackstand, same for the old jacks
Scritto da: Amazon Customer
Caused major damage
The bolt that holds the rubber pad on top sheared off during lift, vehicle slip back off the frame and the neck went through the lower rad support destroying the rad and AC condenser.
Scritto da: glen Schofield
Not very good
Lifts good but handle in wrong place the handle broke off it was welded lower than the base hade to patch it up to finish using it

Související produkty

hot
Omega 27035 Black/White Service Jack, 1 bal
3.1/5

Kč 21973.83

Omega 27035 Black/White Service Jack, 1 bal
3.1/5

Kč 21973.83

hot
AME 14720 Jack Stand, (10 tun na pár)
1.8/5

Kč 6804.31

AME 14720 Jack Stand, (10 tun na pár)
1.8/5

Kč 6804.31

Objevte naši mezinárodní síť

Dodáváme do 28 zemí, více než 200 000 produktů. Zůstaňte v obraze, přihlaste se k odběru newsletteru.

Array