Omix

Brand:Omix-Ada

4.1/5

1667.57

Omix hrdě nabízí vysoce kvalitní náhradní díly pro váš Willys/Jeep, které vždy splňují nebo překračují tovární standardy pro skvělé padnutí a kvalitu, na kterou se můžete spolehnout. Tento náhradní spínač stmívače světlometů namontovaný na sloupku se hodí pro modely 89-96 Cherokee XJ a 90-95 Wrangler YJ. Nahrazuje OE 56003406

OMIX
Brand ‎Omix-Ada
Customer Reviews 5.0 5.0 out of 5 stars 11 ratings 5.0 out of 5 stars
Is Discontinued By Manufacturer ‎No
Item model number ‎17233.04
Item Weight ‎0.8 ounces
Manufacturer ‎Omix-ADA
Manufacturer Part Number ‎17233.04
OEM Part Number ‎56003406
Product Dimensions ‎7 x 7 x 5 inches

4.1

5 Review
5 Star
100
4 Star
0
3 Star
0
2 Star
0
1 Star
0

Napište svou recenzi

Váš email nebude zveřejněn. Všechna povinná pole jsou označena*

Scritto da: Tazisa
Perfect
Amazon sent me first a wrong part in the good box and product reference from the US to Morocco. I have to send it back. They send the good part in 2 days. Perfect. Thanks.
Scritto da: IlDavo
Excellent Replacement for Hi-Low-beam Switch on 1990 Wrangler YJ Steering Column
Successfully replaced the broken headlight hi-low selector switch on my 1990 Jeep Wrangler YJ with this Omix-Ada 17233.04 part. Works great. I wasn't looking forward to "feeling my way" to this part, way down deep on my steering column, behind the dash, but it wasn't s difficult as first feared. I'm sure it didn't hurt that my steering wheel was already removed, as I'd just completed repairing my loose tilt wheel mechanism (*that* repair was decidedly more complex! ;-). Though I found a few on-line videos of folks swearing as they fought to attempt a dimmer switch replacement, I didn't find any one source that showed how to successfully accomplish this basic repair -- probably because, once you locate the old part and illuminate it with portable lighting, the repair, while not difficult to perform, is not easily shown on-camera. Be prepared with low-clearance sockets and/or open end wrenches for the 5/16-inch forward bolt (higher on the column -- close to the dash) and the 3/8-inch rear nut-on-stud (lower on the column, toward the vehicle firewall). ...and don't forget to tape the actuator rod to the steering column, before you remove the old switch, so it doesn't slip out-of-place!
Scritto da: Eric B.
Five Stars
Good quality!
Scritto da: Ted Said
It worked great
replaced my Switch on a 95 jeep YJ , well made product
Scritto da: Jon casads
Replacement part
Haven’t put in yet. So, don’t know. If, works. But, Looks brand new, not used

Související produkty

Objevte naši mezinárodní síť

Dodáváme do 28 zemí, více než 200 000 produktů. Zůstaňte v obraze, přihlaste se k odběru newsletteru.

Array