Peterson Manufacturing 421-18 6,5 LED (S/T/T Light Grommet Oval Pvc), 1 balení, černá

Brand:Peterson Manufacturing

3.6/5

588.87

Peterson Manufacturing Black Oval Grommet má černou PVC průchodku. Připevňuje lampy v oválném stylu. Může být použit s oválnými světly řady 350, 352, 416, 420 nebo 421 as jinými podobnými světly konkurentů. Poskytuje dodatečnou absorpci nárazů pro prodloužení životnosti lampy.

Nejsou k dispozici žádné jednotky
Poskytuje dodatečnou absorpci nárazů pro prodloužení životnosti lampy. Připevňuje lampy v oválném stylu. Lze použít s oválnými světly řady 350, 352, 416, 420 nebo 421 a s jinými podobnými světly konkurentů. Černá PVC průchodka pro zapuštěné držáky oválných lamp.
Brand Peterson Manufacturing
Brand ‎Peterson Manufacturing
Bulb Type ‎LED
Color One
Customer Reviews 4.6 4.6 out of 5 stars 40 ratings 4.6 out of 5 stars
Exterior ‎Painted
Is Discontinued By Manufacturer ‎No
Item Dimensions LxWxH 0.75 x 5.25 x 6.25 inches
Item model number ‎421-18
Item Weight ‎3.04 ounces
Lens Color Smoke
Light Source Type LED
Manufacturer ‎Peterson Manufacturing
Manufacturer Part Number ‎421-18
Model ‎421-18
Position Rear
Position ‎Rear
Product Dimensions ‎0.75 x 5.25 x 6.25 inches

3.6

5 Review
5 Star
82
4 Star
10
3 Star
0
2 Star
0
1 Star
8

Napište svou recenzi

Váš email nebude zveřejněn. Všechna povinná pole jsou označena*

Scritto da: jon d
correct fitting for my trailer
these were needed to fit properly onto my trailer. The ones that come with most trailer light sets were just a bit too small.
Scritto da: Monroe
Works
Works great. Thicker than other brands.
Scritto da: Sawsan
Its very loose
It delt right after my first trip
Scritto da: mreed1
Direct Replacement
This was the only direct replacement for itself on my trailer. None of the other brands I tried fit even though they say they're the same as Peterson.
Scritto da: Robert Bruton
Wont work for fiberglass install
The grommet is fine for use on a metal trailer. I purchased because it fit the replacement Peterson taillight I bought. I knew it possibly might not work on a fiberglass boat trailer but since it was not expensive, I bought it just in case it might work. The groove behind the flange was not wide enough to slip over the fiberglass thickness. I was able to reuse my old grommet. I am sure it would fine for a metal application since metal would not be as thick

Související produkty

Objevte naši mezinárodní síť

Dodáváme do 28 zemí, více než 200 000 produktů. Zůstaňte v obraze, přihlaste se k odběru newsletteru.

Array